Permanent Compression Test Equipment / Deformation Tester For
Rubber Static Test Product introduction Permanent Compression Tester is for Rubber Static Compression Test
Permanent compression of the degree of distortion tester to take
the standard test pieces, sandwiched between the flat panel, the
screw rotation, compression to a certain rate, and then into a
certain temperature of the oven (optional), after the specified
time to remove, remove Test pieces, cooling for 30 minutes,
measuring the thickness, into the formula for compression
distortion.
Clamp specimens between metal plates by tighten nuts to apply a
certain pressure for a required period,
place the device with specimen in a oven with required temperature
for a required period, specimens were taken out and cooled for 30
minutes,
the final thickness is measured for calculating the recovery
performance of specimen.
Specification
Test pieces | rubber φ28.68, 12.7mm (D) foam plastic 50 × 50 × 25mm |
Volume | 20 × 12 × 10cm |
Weight | 11kg |
Standards
CNS-3560,10487, JIS-K6301, ASTM-D395, GB-7759